Side the grip all the way on slowly. Now that the old grips are taken off, you will need to clean the area where the grips go.One item that you need to replace in your ATV is the pair of ATV grips. Next up, you will need to take your razor and slide them down the grip at the top and at the bottom of it. Same thing must be done with the right grip. Let's start with the items you will need. The best thing about this ATV part is the fact that you have plenty of choices to suit your comfort and style. Adding them to your machine can really be exciting. Six streaks would be efficient.

First, you need to slide your left grip on and slide it back off. Putting on new grips can be made as easy. You can use a rag and water to take it off. Dry the hand that doesn't have the soap on your middle finger so you don't get soap on the outside of the grip when you grab it, and put your middle finger inside one of the grips making sure you have soap all around the sides of the grip. When the grips are taken off, toss them aside for the next step. Elastic glue type of material is easy to remove. Toss the old grips aside as you are finished hacking them away. Put the grip down so that the entrance of the grip is in the air.

The right grip where your throttle tube is placed has the bigger hole. Now flat reed suppliers you are ready to install your new grips. • Water • Paper towels • Grip glue • Scissors • Dish soap • New grips The first step is of course to remove the present grips. Your pair of scissors must be sharp enough to do the cutting. Subsequently, pull the sides of the grip so that the grip doesn't just push all the glue up, but it normally goes on top of the glue. You can use towel to remove the excess glue.

Let the grips rest for a minimum of 8 hours untouched until the glue becomes dry. Put them aside and apply soap all around your middle finger and then smear the soap around it with your other hand. When you believe that everything is clean, putting on the new grips can follow immediately. While there are many different methods used by many riders, this one can be very useful especially to neophyte riders. You do this by using sharp scissors to cut around the end of the grip that is furthest away from the handlebars. 

Megosztás a facebookon